#7 intake lifter is stuck. I'm trying to get the stuck lifter to release. As I tap on the tool, the lifter actually goes up the bore. I have to keep pushing the pushrod/lifter back down. If I keep pressure on the pushrod, it feels like I need to hold the tool so it doesn't bounce so bad when I tap on it. If I hold the tool and let the pushrod/lifter vibrate up the bore, the lifter will get high enough in the bore that that the tip of the tool must be getting into the edge of the machined area on the side of the lifter (and ends up burring up the end of the tool). Is that normal? I may be overthinking this but I don't want to screw it up and haven't had much luck getting it to release after tapping on it for 10 - 15 mins (lightly). Thank you.
top of page
Happy Thanksgiving!
We will be closed November 28th-December 1st
to spend time with our family.
Please respect any delays during that time.
Automotive Vehicle Repair & Performance Shop
USA Company Located SE SOUTH DAKOTA
bottom of page
Was going to tell you it's sometimes normal as I read first post. Then I read next 2 and was like, "NVM he got it figured out, Good deal."