I tried using the release method , no luck , ended up pulling R side head to replace the lifters. I am just wondering what's the best , most reliable brand to go with? #4 intake Lifter was broken, 82K miles on it, cup that holds the spring on broke off at it's base. I am probably going with GM 12698946 lifters, seems to be updated part # from my original. Most likely I am going to buy HPTuner to turn off the AFM. Still on the fence about replacing the non AFM lifters, probably will just because I'm there. Too much work for my old arse to keep doin over and over, been wrenchin for 40yrs....lol
top of page
Happy Thanksgiving!
We will be closed November 28th-December 1st
to spend time with our family.
Please respect any delays during that time.
Automotive Vehicle Repair & Performance Shop
USA Company Located SE SOUTH DAKOTA
bottom of page
OK, finally got back to this, it was also throwing a p219b code, fuel trim imbalance bank 2, not misfiring, just slightly rough idle. Did some research on that code, found it's usually bad injector on that bank, so I ran inj balance test, #6 reading was way higher than the rest. They were super hard to get out the first time, probably damaged that one in the process. Ordered new rail and all 4 injectors for that bank. I had to take the fuel rail back out to read the injectors part number of what was installed on the vehicle so they can match it up (wish I knew this when I had it apart the first time), they have to be the same flow rate. Anyway I pulled the VLOM back out, and first thing I did was test it like you showed in the video, and 6 and 4 were leaking like crazy! I had already sliced the aluminum plug I purchased from here, and my VLOM did have 2 steps just like the one in your video. It was pretty tight going in, but just kept smacking it! It was just like in your video, tested it, and it was still leaking tiny bit, hit it a few more times and no more leak! I then started to cut the seals, and my box cutter knife wasn't doing too good, and I didn't really see the need at this point , so I left them. I had precut the vlom plug before I even tried it but it definitely needed to be cut! seems to be running smoother, doesn't feel like it's fighting itself (vlom mod), and I trust that it shouldn't be happening again any time soon. So far just drove it home from the shop (work) and no codes so far!